bubbles and rez and more bubbles, questions, etc.

[charlie]

Yeah ok so I mounted my rez to facilitate bleeding hoping to quiet my pump....I get it running, with lots of bubbes in the rez, filling and filling and then I decide to add a little zerex and BOOOOOMMMM the rez almost turned white with micro-bubbles, wtf??????????????
What am I suppose to do now???

C

[gkiing]

Re-Fill it and don't use zerex. Put the res at the top of the loop to bleed out the bubbles.

[afireinside]

I got 4oz of zerex here and a bit of air in my system. Should I not put it in?

[charlie]

So what's the deal??? Anti-Corrosion treatments cause the water to foam?

C

[Elisha]

tilt your res and fill it to the max with the pump turned off!

[charlie]

After a couple hours of letting it run, the bubbles are about 2/3 gone...but the da*n QUIET ONE 1200 sounds like a coffeee grinder...

C

[John Cena]

You have no clamps on the res??????

I think the bubbles might have transfered to the pump. Give the pump and a the radiator a little tap. On mine when I do that the air patches go back to the res

I have a problem with my resvoir
It's on the bottom of the case, and when I turn the computer off, theres prespiration bubbles on the resvoir top.

See those bubbles there? Is this a warning sign of the water being too hot?

[charlie]

it has hose clamps now....that was just a couple minutes after I started it up....

C