TurboPLL

[Raptor]

Can anyone help me with a TurboPLL for my P4T533-C...

I know allready (talked to Kamu) about the location where i should solder some wires:

yellow wire - R144
red wire - R143
3.3v - R232
ground - C222

but i have for "External PLL" an ICS 952001AF from a ECS P4S5A but i don't know where to connect the wires...

here's the specs of the chip if it can helps.

http://www.icst.com/products/pdf/952001.pdf

he told me:


connect yellow and red wire pin. 2 (ics 95200, output 14.3MHz) and 1.jpg you see
where you connect those wire in motherboard. Is this O.K

[OPPAINTER]

I guess there arn't to many TurboPLL gurus around these Forums.

OPP

[Marci]

I'm still waiting for someone to order one of the Innovatek ones from us so that I can check em out... hadn't realised you can do it by hacking up an old mobo!! Raptor, altho I can't help DO KEEP US UPDATED, as altho there aren't many gurus on here for the pll there never will be if the required info isn't shared...

and on that hint, how do u build a waterchiller if you have a compressor from an old fridge freezer? Someone needs to do a "building phjase change / water chiller" guide step by step for dummies!!

[Raptor]

maybe the TurboPLL might get to secound plan, since i'm getting a 2.5A and it won't be no longer necessary... :P

but if i can't get the 2.5A, TurboPLL will be my only chance, since the P4T533 isn't a gob board yet...