View Full Version : 1/2" Quick-Disconnect Fittings
Çhrist0ph
03-02-2004, 08:22 PM
Where can i find 'em?
ive only been able to find these, they are 3/8"
http://www.xoxide.com/qudi.html
TheWeaseL
03-02-2004, 08:54 PM
I asked the same question a while back. Here's my thread that I asked it in. Nik points out the exact model numbers of the male and female settings for the connects for 1/2" tubing, like I was using. Only down side is it was about 15 bux per set, so it would run a min of 30bux.
http://www.xtremesystems.org/forums/showthread.php?s=&threadid=24047&highlight=COLDER
Çhrist0ph
03-02-2004, 10:03 PM
would these work?
http://www.petco.com/product_info.asp?sku=4743105800&dept_id=%2D2
TheWeaseL
03-03-2004, 12:01 AM
That I do not know...I've had no experience with those, and I don't want to guess and be wrong for you.
Reflex1
03-03-2004, 04:30 AM
it wud work ...but there is a tap to let water through and to stop it ...as long as u make sure u keep it open ;)
try find 1's that dont have the tap 1st ...cuz u dont need it ...if u close it u may burn out ur pump or somethin
xgman
03-03-2004, 12:34 PM
Bruce at cooltechnica.com has them. If not on site, call him. They work great!