Everyday Vdimm settings ?

[sai]

Hi, with which Vdimm do you boot up everyday, I worry a bit about giving my ram 3,2v all day :bsod:

[faruquehabib]

hah! 3.2 should be fine, man. are you running that corsair in your sig?

[Jeff]

On my XP/Barton rigs, I ran at 3.2v-3.25v for over a year on a few of them without any negative side affects.

Now on my A64, I'm running 3.2v 24/7 full-load and I haven't had anything bad happen... yet. :rolleyes:

[TheWeaseL]

I've been running 3.3v for about 2 months now...I've had one of the two sticks I've been running since my KR7A days...and always have been shoving shoving as many volts down it as I can...no probs yet.

[kakaroto]

I ran 3.3v a whole year with my Infineon PC2700 USA @490MHz. no problems, get little warm but with Heatspreader and good airflow it would be no problem.

[sai]

Sounds good, so 3,3v shoould be no prob either, when there's some airflow

[kakaroto]

Originally posted by sai
Sounds good, so 3,3v shoould be no prob either, when there's some airflow

It depends what kind of memory you are using.
Infineon @3.3V gets real hot!

My new HyperX PC3200 BH-5 @3.3v 250MHz, no sweat not warm. :)

[texuspete00]

I been running 3.1v. Hope it's ok.

I hardly ever RMA anything so I yoinked the spreaders. They are coats especially the way they are put on. Thick tape that that hardly has good contact.

[Drisler]

Originally posted by Jeff
On my XP/Barton rigs, I ran at 3.2v-3.25v for over a year on a few of them without any negative side affects.

I now feel better about pumping 3.2v, through my Mushkin, 24/7:p: