Nico - subzero

[Nico]

AMD under 2300mhz, Xabre200 Vapo chilled

gpu cooling: VapoPE
highest gpu oc so far: 325 crashes in Nature at 330
memory cooling: Thermaltake Graphics memory sinks Aluminium
temp of water/gas: -30c hold temp, -9 to +13c GPU
highest memory oc so far (w/wo artifacts): 286w 260w/o
vgpu: 2.2v 320 2.3 330 almost
vddr: std
vref: std
mods(describe the mods you did): Vgpu mod with 100ohm VR
highest score(madmark link):
highest score(futuremark link): 9913 (http://service.futuremark.com/compare?2k1=7535636)

cpu: AXP 1800+ DLT3C
cpu oc: 2293mhz
cpu cooling: Prom Mach2
vcore: 1.7v

mainboard: Abit NF7-S V2.0
fsb oc: 218mhz
chipset timings: cpu interface enabled
nb cooling: Zalman ZM-NB32 with Sunon KD1204PKB2
sb cooling: Globalwin FA420
mosfet cooling: Nil
chipset voltage: 1.7v

memory: Corsair Twinx 3200LL 512
memory oc: 218mhz
memory timings: 2-2-2-11
memory cooling: std
memory voltage: 2.9v

psu: PC Power & Cooling - Turbocool 510w
12v: 12.12
5v: 5.11
3.3v: 3.45

operating system: Win2000
sp: SP2
driver: Xabre3.08
ocing utility: 3d Wizard

location: Queensland, Austrailia
roomtemp: 30 - 35c
casetemp: 35c +
cpu temp: -8c

[Nico]

and for the piccies of my long considered dual cooler (in it's infancy) :D

[Nico]

more...

[Nico]

one more for now.

[Holst]

Looking very good,,

Your very close to 10k... maybee only a few tweaks needed as the clocks look great :D

[afireinside]

:slobber: Howed you get the evap on the card with the stock box insulation thing? It looks so clean it would be hard to tell if that was custom mounted :slobber:
Very nice job and good luck in the compitition :D

[Nico]

Originally posted by afireinside
:slobber: Howed you get the evap on the card with the stock box insulation thing? It looks so clean it would be hard to tell if that was custom mounted :slobber:
Very nice job and good luck in the compitition :D

Mounting the evaporator was very tricky due to the limited room, but it is held on there fairly tightly with two bolts and large washers on the edge of the original enclosure. Nothing larger would fit so it was a bit of a struggle, then I had to chop the bolts to fit the card in the AGP slot.

[skate2snow]

we can say your not mr. dirty;). Good job;)