Hamilton
01-18-2004, 01:21 PM
Ok so I managed to solve the 166MHz FSB problem only to get stuck on another one... :(
I'm running Two IBM GXP120 80GB drives as master drives on each IDE-channel on the HPT372 controller. These two are configured as a RAID-0 array.
When I try to add one or two single drives as slaves on either channel the controller won't find one or both of the master drives.
Let's say I attach one drive as slave on the secondary channel...
Then it won't find the master drive on the primary channel but it will find both the master and the new slave on the secondary channel.
:confused:
I've got the KD7-DN bios with the 2.32 bios for the HPT372.
Before I was using an Iwill XP333-RAID mobo with the same HPT372 but the 2.31 bios for it and then it worked fine to add one or two single drives as slaves to either IDE-channel... :confused:
I'm running Two IBM GXP120 80GB drives as master drives on each IDE-channel on the HPT372 controller. These two are configured as a RAID-0 array.
When I try to add one or two single drives as slaves on either channel the controller won't find one or both of the master drives.
Let's say I attach one drive as slave on the secondary channel...
Then it won't find the master drive on the primary channel but it will find both the master and the new slave on the secondary channel.
:confused:
I've got the KD7-DN bios with the 2.32 bios for the HPT372.
Before I was using an Iwill XP333-RAID mobo with the same HPT372 but the 2.31 bios for it and then it worked fine to add one or two single drives as slaves to either IDE-channel... :confused: