Problem with Mach II and chaintech ZNF-3

[reimo]

Hi,
My prommy hasn`t been detected on USB 2.0 although it is correctly connected.


My temps are @ -15°C in Bios when i set the CPU on 10x260@1,7V is this ok or not?

Why AIDA ( all versions) don`t work on this Mobo?When i start it hang up my system:-(

Who can help me?

Mfg reimo


System:
A64 3200@10x2600@1,7V (I`m still testing)
Chaintech ZNF-3
2x256MB TwinmosTwister 4000
2x80GB Seagate SATA Raid 0
460W Enermax
Radeon 9800 pro (clup3d) ;(watercooled@defaultVcore/dimm@495/385)

[Marci]

When you say "correctly connected" did you rewire the USB cable to match the normal color scheme for your board? If so, that's possibly why.... as it won't be right at the other end of the cable. So... check that first. Make sure at each end of the cable that the colors run in the same order from left to right...

Your temps are fine....

[reimo]

Thanks a lot:-)
I make it at Weekend and replay @ monday.
Mfg reimo

P.S.: sorry for bad english:-)

[reimo]

Hi,
my Prommi don`t work on USB 2.0 :-((
On Prommy the pin assignment is (from left to right):
white - green - red - black

on mobo is red - white - green - black
in user guide from mobo is:VCC - D2 - D1 - GND

user guide Prommy:Red=5V - White= D- ; - Green=D+ - Black =Ground
what is wrong?

Can anybody help me?
Mfg reimo

[JCviggen]

check also if the USB cable hasnt come off the controller during shipping

[reimo]

@MickeyMouse: I did so , but nothing happens:-(
Is the pin assignetment right?
I reinstall windows and than i will see if somethings happen.

@JCviggen: the cable an the connector are ok:-(
Mfg reimo

[Marci]

Ignore all color codes. Wire the USB2 cable so that the colors are the same at each end and plug it straight on, so if goes red green white black at one end, make sure it goes red green white black at the other.

[reimo]

@Marci: ok:-) i will do:-)

reinstall windows hasn`t fixed the problem:-((
Mfg Reimo

P.S.:Sorry for bad english:-)

[reimo]

@Marci: no effect:-((
In Devicemanager is USB ok but when i connect the prom he will don`t find the prom:-(
I think the Prom is defekt....
Mfg reimo

[JCviggen]

It could always be the cable which is bad, but have you contacted nVENTIV support ? That should be the first thing you do :)

It is extremely unlikely the problem is related to the chip controller. Have you tried turning the wire around? If there is a physical connection between the CC and the USB on the mainboard then Windows will give you an error when the wire is turned the wrong way around.

[reimo]

Hi,
no,there is no error in windows devicemanager...
the nVentiv support doesn `t answer :-(((
Mfg reimo

[JCviggen]

you sure you used the right addy?? support@nventiv.com? when did you send it? Im sitting right next to the support guy and he says he hasnt received anything...

PM me the info if you like?

PS : do not contact the german nventiv addy about support. only nventiv.com handles support.