Rukee
01-11-2004, 03:10 PM
I`m running a Vapo unit on a 5950u BIOS flashed 5900u golden sample card and the thing will not reconize negitive temps, it goes down to zero then resets at 255* and starts to count down from there setting the power failure error and extreem throttling. I found a workaround with the 45.23 drivers if I boot into windows and go to the temp display then unplug the power from the VC vapo unit the temp of the card will raise to 255 then go to zero, I reboot and it locks the temp at zero and then I can run and OC it. But the 45.23 don`t see the card as a fx5950u and I`m sure the 5*.** drivers would give alot better performance.
...sept the temp trick won`t work with them. The temp rises up to about 270* then goes straight to 16 above passing right over zero and then not being able to be locked at zero.....it just keeps reading the right temp and when the vapo is restarted the temp goes back down under 16 and into the high 200`s.
can someone dissable the temp function in the drivers??? Or reset the temp scale to fool it into thinking -23* was realy 13* so it would start and run propper as a fx5950u without a fancy startup procedure and the extreem throttling??
...sept the temp trick won`t work with them. The temp rises up to about 270* then goes straight to 16 above passing right over zero and then not being able to be locked at zero.....it just keeps reading the right temp and when the vapo is restarted the temp goes back down under 16 and into the high 200`s.
can someone dissable the temp function in the drivers??? Or reset the temp scale to fool it into thinking -23* was realy 13* so it would start and run propper as a fx5950u without a fancy startup procedure and the extreem throttling??