some direction needed

[Olly_K]

OK, I can hear you all groan already, but I've finally got my DD tower29 case and I've start to place a few things in there, trying to figure out routing of tubing, pump/res placement, etc.

So, take a quick look at these pics:

http://www.ollyk.com/projectsaifu/ramin1.jpg

http://www.ollyk.com/projectsaifu/ramin2.jpg

My current train of thought is:

my 980x and mobo block on the 120.4 in the front.
The 2 480's on the 360 in the bottom.
2 loops.

OR, as I'm thinking of adding another 480:

980x and mobo block onthe 360
the 3 480s on the 120.4
again, 2 loops

OR !! Would I be better putting it all in one loop ?

Thanks in advance chaps <3

[MagisD]

My question to you is what's simplest solution. I tend to over think, so do a lot of people but kiss ( keep it simple stewie) and it should work out.

But double pump in different locations in a single loop seems to be generally the most effective with current hardware.

Sent from my X10a using Tapatalk

[Olly_K]

Thanks for your reply. I'm not after simplicity, I'm after efficiency. Im just tubing up a single loop right now, just to test it. I've never done single loops really, only double/triples.

I've got my 2 ddcs 18w on a XSPC dual top, so they're next to eachother. just getting most of the bubbles out of the system and I'll boot it up and see what the temps are saying :)

[leo_bsb]

I think your supreme HF is not mounted on the suggested position by the manual.
check that.

[Olly_K]

thanks, it's really just for mock up at the moment. I think I'm going to run a single loop. Now I just need to fit it all in there nicely :D

[MagisD]

Now I just need to fit it all in there nicely :D

That the FUn FUN Funnnnn fUUNN Fuuuu Part .... huh did my twitch come out again.