Koolance MVR-40 + Bitspower 1/2'' Compressions

[jumper2high]

Anyone knows if the BP 1/2''ID - 3/4'' OD compression fittings can be mounted on the MVR-40 mosfet blocks or do they hit the mounting brackets and screws, and would need some extenders?

[wesley]

You can use the koolance rampage 3 extreme block as a reference point for spacing. My BP 1/2inch comps couldn't fit. Only 45 comps are good to go. BP barbs are good too.

Wes

[jumper2high]

Or those little adapters that raise the fitting a few mm up?

What was the problem - clearance with the screws or the two compressions among eachother?

[Koolance]

They will hit each other. We only show compatible nozzles in the "Add Nozzles?" option on each of our water block's web pages (http://www.koolance.com/water-cooling/product_info.php?product_id=660). Our compression for the smaller 1/2" x 5/8" are also not shown because they would conflict with one another. You would need to use some swiveling fittings (ours fit, I'm not sure about BP), or hose barbs for 3/4" OD.

Tim

[jumper2high]

Thanks Tim!