Setix
03-08-2010, 12:28 PM
Ok guys I have searched for a solution for this but I haven't found anything. I have a cosmos s case and am planning on running a dual loop through. The 2nd loop is a XSPC RX360 in push/pull that I want to mount off the back of the case...however I know that the rad plus six fans, liquid, hardware..etc is going to weigh a ton, so I need a bracket or standoffs etc to mount it...
...is there a pre-built solution out there for rear mounting a rad and still leave room to access my PCI slots? I had already planned to use the center fan as the mounting point to reduce the moment arm around the fan mount at the rear of the cosmos.
At first I thought about the swiftech radbox version2, but I heard they were flimsy...
..anyone got any other suggestions?
...is there a pre-built solution out there for rear mounting a rad and still leave room to access my PCI slots? I had already planned to use the center fan as the mounting point to reduce the moment arm around the fan mount at the rear of the cosmos.
At first I thought about the swiftech radbox version2, but I heard they were flimsy...
..anyone got any other suggestions?