* Posible Project * what do you think ? *

[darthcani]

Hi to everyone, let me explain this, i want to made a WC ring simple very simple and i think this setup with this case :

Lian Li x500
Ek with Pump Reservoir 100
Black Ice Xtreme 1x120 RAD
CPU Block someone line heat killer or EK

i dont know if the Ek reservoir and pump included fit like pic shows, but in
alternative is possible Swiftech MCRES Micro Rev. 2 Small Form Factor in the same place of the EK, so what do you think ? Thanks !!!

http://img714.imageshack.us/img714/3695/x500d05.th.jpg (http://img714.imageshack.us/i/x500d05.jpg/)

[Kibbler]

It'll work just fine, just make sure you have enough rad for whatever CPU you have in mind. :)

[darthcani]

It'll work just fine, just make sure you have enough rad for whatever CPU you have in mind. :)

For now will be for i5 750 4ghz or another option with a mod the front of x500 between chassis and the front cover fit a 2x120 RAD is an option ...

[darthcani]

Any idea how it is posible fill the circuit with this lay out ? because i use the up of reservoir and one out in the bottom so where i can fill the circuit ?

[mattkosem]

another option with a mod the front of x500 between chassis and the front cover fit a 2x120 RAD is an option ...

I'd do that instead of what you have pictured. A 1x120mm rad in the exhaust of the case will get you much worse temps than a 2x120 at the intake. Temps will probably not be great on a single 120mm rad with a quad at 4ghz. Moving the rad to the front will also allow you to use one of the side inlets on the res, so you won't need to worry about how to fill it anymore at that point.

--Matt