How do I change the spinning wheel on EK-BAY SPIN Reservoir?

[dhc0329]

Do I just use needle nose wrench to brutfully pull out the exisitng one
and push in the new wheel?

Anyone has experience in changing the wheel?

[dean.collins]

Do I just use needle nose wrench to brutfully pull out the exisitng one
and push in the new wheel?

Anyone has experience in changing the wheel?

do you have any video of it working?..... curious on how it looks.

[Blizzy]

do you have any video of it working?..... curious on how it looks.

http://www.youtube.com/watch?v=kaz5k1IF82s

[dean.collins]

Thanks for that, looks good but looks like it takes up more room than the

"XSPC Dual 5.25" Bay - DDC Dual Pump Liquid Cooling Reservoir"

which is what i'm also considering using. Does anyone have any comments about the XSP? BTW do you know if you can open up a XSP to clean it out? says the front panel is removable but not sure if that is for asthetics or actual access.

[PeterStoba]

Thanks for that, looks good but looks like it takes up more room than the

"XSPC Dual 5.25" Bay - DDC Dual Pump Liquid Cooling Reservoir"

which is what i'm also considering using. Does anyone have any comments about the XSP? BTW do you know if you can open up a XSP to clean it out? says the front panel is removable but not sure if that is for asthetics or actual access.

You can't access it, that would open up alot of problems.

[JackOfAll]

Do I just use needle nose wrench to brutfully pull out the exisitng one and push in the new wheel?

Anyone has experience in changing the wheel?

No wrench required! It's loose - it has to be or it wouldn't turn. Just remove the front panel and use your fingers to change the wheel. ;)