View Full Version : questions about HEATKILLER Rev3.0
quattro_
02-20-2009, 01:49 AM
i just ordered the block but did not receive it, i noticed two versions of the copper top the rev.3 and rev.3 lc, whats the difference ?
also the block contains stainless steel is that OK ?
Vapor
02-20-2009, 02:02 AM
There's actually three versions: Cu, LT, LC.
Cu and LT have the same plate, just a different top. They should perform the same.
LC is the low cost version with lower internal fin count and a simpler design to manufacture (with lower performance, presumably)
quattro_
02-20-2009, 02:11 AM
thanks, i think mine is the Cu its the first one in this list :
http://www.aquatuning.de/index.php/cPath/22_97/filter_by_manu/36
and is stainless steel a problem with copper?
quattro_
02-20-2009, 04:49 AM
anyone???
Vapor
02-20-2009, 05:05 AM
Stainless is fine. I'm not sure it even comes in contact though.
quattro_
02-20-2009, 05:21 AM
but even if it did its not a problem, that's what your saying right? no corrosion? im just using distilled water and pt nuke !
hotdun
02-20-2009, 07:13 AM
but even if it did its not a problem, that's what your saying right? no corrosion? im just using distilled water and pt nuke !
You should use caution with mixing any metals, no matter how close/far they are on the galvanic table (http://corrosion-doctors.org/Definitions/galvanic-series.htm). That being said, the HK 3.0 does not have any internal stainless steel contact.
quattro_
02-20-2009, 07:42 AM
thats good to know thanks for the info :)