TJ-07 PA120.3 Mounting

[Grinch]

How are people mounting their pa120.3's in the bottom of the TJ-07? :shrug:

[BlueAqua]

Hammond Project Box:

Screw mounted to the chassis, double sided tape to the radiator.

http://img.photobucket.com/albums/v297/BlueAqua/IMG_2458.png

[Grinch]

anybody else? i read somebody used velcro?

[echn111]

Rads are resting on two layers of AcoustiPack foam/rubber on the bottom of the case and held at the top by a few pieces of folded Tygon tubing.

This holds the rads properly - even if you turn the case upside down and shake it.

But the real reason I went for this is that it prevents any vibrations being transfered to the case from the fans on the rad. (No drilling/modding required was just a bonus.)

[Waterlogged]

Grinch, poke through this topic (http://www.xtremesystems.org/forums/showthread.php?t=174968) and see if anyone else besides AndyM posted a work log.

[BlueAqua]

Check out Turtletrax's build log too here>

http://www.xtremesystems.org/forums/showthread.php?t=199217

[Serpentarius]

there's an old worklog ... TJ07 + PA120.3 + PA120.2 + PA120.1 = Photos of my version of this. (http://www.xtremesystems.org/forums/showthread.php?t=149265)

[adam9977]

I used Velcro for mine. Not that it really matters...it can't move very much anyway considering the amount of space it takes up. Velcro secures it very well even for transport.

[ladderman]

This is how I mounted my PA123.0 in the base of my TJ07

I decided to raise the PA120.3 up because I wanted the fans to show fully through the mess. So I used rubber spacers.

I also drilled three sets of holes in the case base so I can move the rad right or left of centre.

The reason for this is because I needed to work out the best way to get the two D5 pumps down there, and the rad might need to go to one side to make room.

[Zehnsucht]

This is how I mounted my PA123.0 in the base of my TJ07

Wow! :clap:
:up: for being Xtreme :)

I'd never dare to start drilling my radiator. Especially not if I had a TC, being expensive and all.

[hoax]

anybody else? i read somebody used velcro?

velcro works .. no mods required, sorry for the old pics: (if you need better pics of the springs with measurements, I still have them around)

http://i41.photobucket.com/albums/e299/cagiali/IMG_2270.jpg

http://i41.photobucket.com/albums/e299/cagiali/IMG_2287.jpg

http://i41.photobucket.com/albums/e299/cagiali/IMG_2289.jpg

http://i41.photobucket.com/albums/e299/cagiali/IMG_2300.jpg

http://i41.photobucket.com/albums/e299/cagiali/IMG_2308.jpg

http://i41.photobucket.com/albums/e299/cagiali/IMG_2322.jpg

original idea from XS member Clokker :up:

[Grinch]

springs? good idea :)