What barb sizes do these come with?

[Raadster]

Im getting the following parts listed below;

XSPC reservoir top
Fusion V2 block
laing ddc 3.2 pump

Now id like to go with 7/16'' tubing over 1/2'' barbs, but i cant find any information regarding with size fittings come on the above parts. Im assuming they come with 3/8'' holes so all i need to buy are 3/8'' to 1/2'' adapters, I assume this because if they came with 1/4'' holes how would anyone fit 1/2'' barbs.

But if anyone could chime in and confirm this id appreciate it.

[clone38]

Just buy the barb size you need mate as they will fit all the parts you have ordered.

[Spankyfart]

1/4'' holes

[zanzabar]

for the mcp355 res top dosnt come with barbs, and u would need g1/4 i like bitspower non compression. and the fusion v2 comes with 1/2" g1/4 but i would swap them. and i dont think that the xspc comes with barbs.


and why use the smaller tubing u still need clamps and if u get good tubing it dosnt come loose, like primoflex or fesser

[Raadster]

Just buy the barb size you need mate as they will fit all the parts you have ordered.

Thanks that clears things up.


for the mcp355 res top dosnt come with barbs, and u would need g1/4 i like bitspower non compression. and the fusion v2 comes with 1/2" g1/4 but i would swap them. and i dont think that the xspc comes with barbs.

and why use the smaller tubing u still need clamps and if u get good tubing it dosnt come loose, like primoflex or fesser

So to sum things up, you say I'll need 2 of the g1/4 to 1/2'' for the res top, is that 1 for inflow and 1 for outflow? or is that 1 for inflow and the other for the line to fill the system.

And also get 2 more for the fusion v2 as you say the ones supplied should be swapped.

[fart_plume]

Ok G1/4 is the standard threading on all barbs and components. Just order your 1/2" barbs and you'll be good to go.(you'll a barb for every port in every component, other than if you get plugs for unused ports).

[Raadster]

Ok G1/4 is the standard threading on all barbs and components. Just order your 1/2" barbs and you'll be good to go.(you'll a barb for every port in every component, other than if you get plugs for unused ports).

ahh g1/4 is the threading, thanks for that im set now.