SuporterPoli
12-28-2008, 01:36 PM
Because the only way to use "big" tubing like 1/2" ID on some waterblocks with compression fittings is the angled fitting i am putting out the following question:
How restrictive are angled fittings? 45 or 90degrees from Bitspower lets say.
So something like this:
http://us.st12.yimg.com/us.st.yimg.com/I/sidewindercomputers_2030_32527598
http://us.st12.yimg.com/us.st.yimg.com/I/sidewindercomputers_2031_17480596
in a loop with a big radiator,2gpus,mobo,cpu,res,2pumps(mcp355).
Should i resign and use barbs or switch to smaller id tubing?
Example of a small block:
http://shop.anfi-tec.de/images/product_images/popup_images/43_0.jpg
How restrictive are angled fittings? 45 or 90degrees from Bitspower lets say.
So something like this:
http://us.st12.yimg.com/us.st.yimg.com/I/sidewindercomputers_2030_32527598
http://us.st12.yimg.com/us.st.yimg.com/I/sidewindercomputers_2031_17480596
in a loop with a big radiator,2gpus,mobo,cpu,res,2pumps(mcp355).
Should i resign and use barbs or switch to smaller id tubing?
Example of a small block:
http://shop.anfi-tec.de/images/product_images/popup_images/43_0.jpg