Quest for stability...

[acePROD]

Hi everyone

After installing a 437W peltier on my FX-60 I started dreaming of unimaginable overclocks, but reality (and limited RAM timings knowledge) brought my imagination to a halt. I’ve reached 3.1 GHz and my system is running quite ok but stability is another issue...
At this point nothing seems to increase the stability time in Orthos and I’ve tried the following:

1)Increased the CPU voltage up to 1.7v... nothing
2)Increased the chipset voltage to 1.62v...nothing
3)Decreased the HTT multiplier to x3... nothing
4)Used various RAM dividers...nothing
5)Relaxed RAM timings to 3-4-4-8...nothing

I’m attaching all relevant details for anyone so kind to offer advice.
Thanks in advance.

[acePROD]

I have changed the command per clock to 2T and reduced the DRAM voltage to 2.8v but still I cannot pass the 2 minutes in Orthos. :confused:

[pixie]

Ouch.

I assume that everything is already 100% on default settings? You'll have to start from zero.

[acePROD]

Actually I've managed to stabilize the OC by reducing the vcore to 1.5v and setting all memory settings to auto appart from CAS/tRCD/tRP/tRAS/CMD which are set as shown in the BIOS photos above. I'm Orthos stable for 1 hour and 52 minutes so I'm sort of ok. During the weekend I'm going to try to push it a bit more.

:( It's a bit dissapointing though that nobody even expressed an opinion about my post...