D-Tek Fuzion V2 + Feser 45 1/2" Compression + Feser 1/2" Compression

[barfastic]

Hey guys,
i was wondering if u can put a feser 45 degree compression fitting and a normal compression fitting on the fuzion v2.

Both fittings are 1/2"ID - 3/4"OD.
i was thinking that if you put the 45 degree one on first and put it at an angle facing away from the center of the cpu block a compression 1/2" fitting will be able to fit as well. Seeing as the width of the 45 is significantly thinner at its bolt.

Can any one try it out, or is there anyone who has tried it? please let me know!

(See pics below to see the thinner base of the 45degree fitting.)
http://www.chilledpc.co.uk/shop/images/large/feser-45comp-1m.jpg
http://www.chilledpc.co.uk/shop/images/large/Picture%20200.jpg

[kadozer]

You mean like this? I believe Fuzion ver.2 is farther apart then ver. 1 which is mine below.

http://www3.picturepush.com/photo/a/1040601/640/1040601.jpg

[barfastic]

well, not really. i was thinking of a normal compression in the middle and a 45 bent one on the outer threading. but by the looks of it doesnt look possible. are those 1/2"ID 3/4"OD fittings?

[kadozer]

well, not really. i was thinking of a normal compression in the middle and a 45 bent one on the outer threading. but by the looks of it doesnt look possible. are those 1/2"ID 3/4"OD fittings?

no not possible with normal compression and yes that size