Wich its the best loop for me??

[manyga]

With this:

http://i247.photobucket.com/albums/gg140/mgneku/DSC07933.jpg

Wich is better?


This??

Loop 1: Pump-> VGA -> CPU -> Rad-> Res -> Pump ( This loop is more clean and less restrictive)

http://www.pctunerup.com/up/results/_200808/20080818051822_Loop1.JPG

This??

Loop 2: Pump -> Rad -> CPU -> GPU -> Res -> Pump ( Use a Bitspower Crystal 90º Fitting in pump exit)

http://www.pctunerup.com/up/results/_200808/20080818051830_Lopp2.JPG



Or other??




Thanks a lot guys!

[roofsniper]

its always best to have the cpu go before the gpu and have the rad right after the pump but a 90 degree elbow wouldn't be the best for the pressure. you can't turn the rad around the other way?

[Boogerlad]

1st one because the angle at the pump would make it perform like the stock pump with the angles. btw, loop order doesn't matter. just res before pump and you'll be fine.

[manyga]

Thanks guys! I think that the first loop is better too....

But the problem is VGA before CPU....Much difference?

Thanks!

[jiffy2]

Thanks guys! I think that the first loop is better too....

But the problem is VGA before CPU....Much difference?

Thanks!
The difference should only be a fraction of a *C. Martin's testing shows that with a 300W heat load, the difference between water in and water out is only about .5*C, so the difference will be even less than that in your loop.

[manyga]

Thanks bro!