View Full Version : Do 1/2 BP fit on a mcw-60?
roofsniper
08-16-2008, 08:38 AM
i was going to get these: http://www.ncixus.com/products/index.php?sku=28960 but i wasn't sure if they would screw on tightly onto a mcw-60. i think i remember seeing something about how they wouldn't fit but i wasn't exactly sure. if they don't fit is there a way you can make them?
roofsniper
08-16-2008, 08:44 AM
No way the BP Comps (1/2" x 3/4") will fit, they are 1" diameter....:shocked:
ya i was pretty sure they wouldn't. anyway they could be extended to fit?
thanks
roofsniper
08-16-2008, 09:24 AM
didn't know if i could get something that would extend out the socket so i could put the compression barb on without touching the block.
roofsniper
08-16-2008, 09:36 AM
got a link?
roofsniper
08-16-2008, 10:14 AM
thanks ill probably get compression for my cpu and get those for my gpu.
RickCain
08-16-2008, 11:05 AM
Just run 3/8" x 1/2" compression and call it a day! You might lose .5c off your loop but beable to use compression.
RickCain
08-16-2008, 11:14 AM
3/8" ID tubing .....:down:
Opinion, obviously :shakes:
The best part of 3/8" tubing w/ compression fittings is your not stuck using a EK block on your CPU!! :rofl: Not to mention the temperature difference is about as much as adding a 90 connector to a 1/2" loop.
freakgeek1337
08-16-2008, 12:39 PM
Here we go AGAIN. The Opinions War. C'mon people let's not turn this into Flame Fest 2008, you're better than that...:down: