Striker II "PCI INIT" error

[MaestroX]

I have been using my system for a good couple of months before this error occured.

Today I recieved some new hard drives, which I installed. Upon trying to restart my computer, I get the message:

"PCI INIT"

On the LCD poster. After trying every configuration of hardware I could possibly think of I still can't get it to boot.

[rapid64k]

what is your bios?
Try removing the battery disconnect all power leads leave for 20mins if that donk work try 5 hours.

[MaestroX]

From what I remember it was 1001, I think, though I can't access my Bios at the moment.

Thanks for the advice, I'll report back in 5 hours ;)

[Vatos_locos]

try to remove your cpu and reinstall it what cooler do you have ?

[MaestroX]

I use a water cooling loop. I'll give it a go if removing the battery with a couple of hours doesn't fix the issue.

[Vatos_locos]

try not to tight the bolt too much this board have some issues with this and if you tight them too much she gives a Cpu init

[MaestroX]

Ah I see, I'll give it a go, though I'm not getting a "CPU init" error I'm getting "PCI init" error.