View Full Version : pc power and cooling 475w
gouda96
09-11-2003, 07:42 PM
anyone know how to vmod the pcp&c 475w psu?
i need 12v, 5v, 3v.
thanks.
Riska
09-13-2003, 01:16 PM
Ther should be 3 small pots inside hust turn them a little!
gouda96
09-13-2003, 01:19 PM
cool, I was hoping it had pots in there, but hadn't gotten around to checking yet. That makes everything nice and easy.
gouda96
09-14-2003, 09:01 PM
should i do this while the computer is on, or make small adjustments and turn it on? Where do i take the voltages from...or should I just trust the winbond hardware monitor for the nf7-s rev2?
Riska
09-15-2003, 04:21 PM
Turn them alittel clockwise and then bott into bios to check and then turn of and turn some more and check again!
gouda96
09-15-2003, 05:36 PM
so bios/mbm/hardware monitor are fine for checkign that...ok thanks...will do this tomorrow being that i don't have any classes until 6:30pm on tues.
Riska
09-16-2003, 11:25 AM
Jep it is fine for that!
Silversink
09-21-2003, 01:43 PM
If you bought a PC Power And Cooling PSU from PCP&C and you have a P4, they will send you a free 'Dummy' 5volt resistor to help the 12v rail.(You just plug it in to any unused Molex connector)
I got one last week, I wasn't thinking and used Velcro to mount it in my case and the velco started to melt lol
I then used a nut and bolt and bolted it to the PSU itself.