silver what do you use?

[laKewl]

title says it all, what do you guys use? and how much is it?
thanks :)

[n00b 0f l337]

You mean brazing rods?
I use 45% and 15% ones. The 45% are pre fluxed rods. The 15% are normally Dynaflow or Stay silv phosphorous 15's.

[A/\/\/\C]

normal easy flow fluxed brazin rods for normal joints and pure silver rods for brass to metel or copper to metel

[laKewl]

from what i can find on ebay thats going to cost like 150 LOL, OUCH but i really dont want to kill my self so its only money not my hand :D

[PhilippF]

I very much like the Dynaflow rods from under-the-ice (even though I live in Germany, I order them from overseas). If I have to use silver rods, I use cadmium-free 45% silver with Harris Black Flux (also from under-the-ice) which works best for me.

[laKewl]

Dynaflow comes up alot ill try and go with that stuff lots of people (from what i have seen) are using it and say its good thanks for the feed back guys :)

[teyber]

i just use 15% and i get very nice joints. They are VERY economical and can look quite nice if you clean them properly. 45% looks awsome but its really down to if you want to spend that much. i would buy 1 lb of 15% brazing rods, which i got for like 30$. it seems i use a ridiculous amount of brazing rods and still have tons left.

regards

eDIT:

sometimes you need to use 45%, id buy the smallest amount of 45% for emergencies you can.

[Xeon th MG Pony]

I use 5%, 15%, 45% w/ White brazing flux.

45% is used for ferrus to copper joints or on a joint I think I'll need to de-braze to do more work.
15% is used through out most the builds
5% is for fast prototyping and repairs.