kohlersc
03-05-2008, 10:17 PM
Ok so I grabbed the cool tap threader from McMasters. This should allow me to tap the Microres top for the EK barbs...however I need a Tap Wrench that can handle this puppy.
Problem 1...two different hardware stores down here...both were not able to come up with a hand wrench solution for this. In fact they were extremely stumped as they sell taps close to this with the same sized top square section and yet couldn't figure out what someone would do with them once they bought them since they didn't sell anything that could then be used to turn them :shrug:
I am not a tool guy by nature. I wish to be...please enlighten me. What do I need? Where can I get it? Help!
Problem 1...two different hardware stores down here...both were not able to come up with a hand wrench solution for this. In fact they were extremely stumped as they sell taps close to this with the same sized top square section and yet couldn't figure out what someone would do with them once they bought them since they didn't sell anything that could then be used to turn them :shrug:
I am not a tool guy by nature. I wish to be...please enlighten me. What do I need? Where can I get it? Help!