Virous
02-21-2008, 12:34 PM
How can i change the nozzles on my fusion block to fit a 1/2 inch hose on them?
I gave my mate the connectors and now i need them (id10t).
I was thinking i could push some 3/8 hose over the nozzles, then 1/2 inch hose ontop. and clamp it down good. would that work. Any ideas appreciated. I looked up and i cant seem to find 3/8 to 1/2'' pipe connectors.
I gave my mate the connectors and now i need them (id10t).
I was thinking i could push some 3/8 hose over the nozzles, then 1/2 inch hose ontop. and clamp it down good. would that work. Any ideas appreciated. I looked up and i cant seem to find 3/8 to 1/2'' pipe connectors.