Turion Ml-34 in desktop

[Metalsoft]

Hey everyone, I'm new here, and would like to ask a question?

I put a turion ML-34 in my abit NF-8,(yep a desktop) and overclocked it to 2.4ghz (265x9).

When I put the Processor in, it defaulted at 1.5 vcore. This is much higher than the 1.325-1.4 it says. My sempron 3000+ i had in it, would default at 1.4.

My temps at said speeds are 34 system, 35 cpu. 41 load (OCCT30min).

Is the 1.5 vcore going to kill my chip?

Thanks

[Power5]

Voltage should be okay since its on 90nm manufacturing. Temps look very low, you could probably bump the speed up a bit more, if the voltage will allow. Dont know what the maximum temp is on a mobile chip though.

[Gothic]

Mobile CPUs are known for higher temp tolerance. If I'm not mistaken, desktop S754 90nm CPUs will do it fine up to 70C. Mobile ones should have a +15~20C margin