View Full Version : Darn voltages
STEvil
08-03-2003, 10:02 PM
Yeah.. EPOS 8K3A+.. go figure.
PSU Reads 12.45/5.02 @ the molex.
Hell-Fire
08-04-2003, 10:19 PM
How is yer 3.3v reading from the psu?
STEvil
08-04-2003, 10:24 PM
Didnt check it for very long, but it was pretty much on 3.31 at the mosfet and on the molex.
I just checked them while in the bios, too, cause I was busy doing the R468 mod to get my AGP to 1.74v..
Hell-Fire
08-04-2003, 10:33 PM
I see.
Its funny, MBM is failry close on my 3.3v and 5v rails..but its way off on my 12v rail...like almost a full 1 volt off.
STEvil
08-04-2003, 11:50 PM
Grab a multimeter and check at the molex.
Mine measure fine at the molex, so the board is the cause for fluctuations.. 8-/
Penti
08-05-2003, 12:02 AM
Measure directly at the board or at the atxconnector (yes it can have a differnt voltage there, but the boards also seems to measure little to low)