ip35 pro post code error

[lazy]

After a few OC sessions the computer bsod. After reboot I get an error code of C1.

After turning the computer off/unplug power cord/pushing power buttom/removing battery for 20min + and clearing cmos..

The board will not boot if i go into the bios

Once i reboot, if I DONT go into bios, when it would boot up properly BUT,
if i go into bios to even change the time or change anything, the system will
hang and give me c1 error code...

Did I do something wrong? :shrug:

[Heidfirst]

You have reset the Vdimm to 2.0V or whatever (using I DIMM if necessary to do so)?

[lazy]

stock vdimm is @ 1.8v

the only way for me to oc now is from U-Guru..

after i went through all the resettin procedures why is it still hanging?

[Heidfirst]

Pretty sure that you'll find that it needs more than 1.8V for it's rated timings/speed - all DDR2 Ballistix is 2.2V.

[lazy]

i know it requires 2.2 but it has no problems running @ 1.8.. has been working...

ill try to leave the battery out for a longer time

[Heidfirst]

Try it at 2.2V & see if it makes a difference.
C1 is a typical code without enough RAM voltage.