Start
08-05-2007, 02:41 PM
So finally decided to get my feet wet and start with some water cooling. Shooting for a good budget and performance. Not look for the best, but better than air cooling. I will just have a single loop cooling my X3210.
D-Tek Fuzion w/ 3/8" Barbs
MCR220 w/ 3/8" Barbs
ClearFLEX 60 Tubing 3/8" ID / 5/8" OD (10')
Pentosin G11
Dangerden Fillport - Delrin w/ 3/8" Barbs
3/8" T Line for 3/8" ID Tubing - Black
Plastic Tubing Clamps - Medium Black (10x)
MCR350 Pump (Picking this up locally for $35 off of someone)
Opinions would be appreciated. Probably going to mount this internally, but not sure how yet. I'll post diagrams of my proposed loop later.
D-Tek Fuzion w/ 3/8" Barbs
MCR220 w/ 3/8" Barbs
ClearFLEX 60 Tubing 3/8" ID / 5/8" OD (10')
Pentosin G11
Dangerden Fillport - Delrin w/ 3/8" Barbs
3/8" T Line for 3/8" ID Tubing - Black
Plastic Tubing Clamps - Medium Black (10x)
MCR350 Pump (Picking this up locally for $35 off of someone)
Opinions would be appreciated. Probably going to mount this internally, but not sure how yet. I'll post diagrams of my proposed loop later.