Red Dawg
05-26-2007, 03:29 AM
My first try here at overclocking :eek:
I have a E6600 running on a Asus Striker motherboard and I did a moddest overclock, took it from 2.4ghz to 2.7ghz by raising the FSB from 1066 to 1200.
All went well, ran Orthos for 12 hours fine.
Now if I go any higher in FSB and boot into windows, PCProbe gives me an alarm and tells me that my Vcore is too high it's reading 1.39v and my CPU VTT is too high as well it's at 1.38.
But I left my voltage in my bios on AUTO (Default) didn't change it at all.
This normal? should I manually set the voltages? I was hoping to go as high as I could go in FSB without raising the voltages.
I have a E6600 running on a Asus Striker motherboard and I did a moddest overclock, took it from 2.4ghz to 2.7ghz by raising the FSB from 1066 to 1200.
All went well, ran Orthos for 12 hours fine.
Now if I go any higher in FSB and boot into windows, PCProbe gives me an alarm and tells me that my Vcore is too high it's reading 1.39v and my CPU VTT is too high as well it's at 1.38.
But I left my voltage in my bios on AUTO (Default) didn't change it at all.
This normal? should I manually set the voltages? I was hoping to go as high as I could go in FSB without raising the voltages.