Orthos Testing

[GuitarFreak1857]

ok guys, so far i've got my opty to 2700Mhz at stock volts, 300x9, my ram running at 225Mhz. so when i go to run orthos or prime95 after it runs for 1-3 hours or so it freezes and puts a high pitched sound out of my speakers. what should i do?

~thanks

[m411b]

ok guys, so far i've got my opty to 2700Mhz at stock volts, 300x9, my ram running at 225Mhz. so when i go to run orthos or prime95 after it runs for 1-3 hours or so it freezes and puts a high pitched sound out of my speakers. what should i do?

~thanks

add vcore or loosin RAM timmiings..

[Lenny_Nero]

Have you used anything else for testing ?
With my RDX200 it will run anything else for as long as I want to leave it but I 'always' have problems with orthos... ah just seen you have used prime 95 as well.

You could back it off a few on the FSB, or bump up the volts a small amount with the % and Vcore.

I dont know what your cpu is for std volts, but I am using 1.275 volts and 107.2% to give me ~1.369 but I have found using the startup Vcore of 1.4 will make sure there is the power bump for starting, I dont need the start one 9 times out of 10 but it can just hang or not find files for that odd time if not.

I have a chart to help with the % volts I have some just for the RDX200 (I think the expert comes from this) and just one for A64 they are almost the same