More effective evap cooler

[max_Jaker]

well heres a revamp of my old idea for an even more efficient bong cooler.
original seen here http://www.xtremesystems.org/forums/showthread.php?t=78658&


http://img.photobucket.com/albums/v458/max_Sleeper/newevapcooler.jpg
copper center tube
pump 1 goes to outside chamber (this pump needs to have more flow than pump2)
pump 2 to waterblock on cpu and to showerhead
water level is controlled by installing smaller elbow on bottom and larger one on top it will cycle its level if u build that part correctly also u will want to make a level gauge on the outside showing top and bottom elbow heights so u can fill it correctly :)

[welshtom]

ok, you guys have my interest in this bong cooling malarky.

Im going to build one next week, it wont be like yours above, but more the simpler versions with a single chamber.

If you have the design dude, build, thats the best way to see if its any good :p

Tom

[Turtle 1]

I think a bong is better suited to other uses. As I can tell you are already aware.

[STEvil]

bongs really dont need to get a lot more efficient.

If you want to remove more heat just make it taller really.

[serialk11r]

WTF how would that thing be more efficient? A double loop with a bong cooling a really high fpi, double row rad would be efficient, while being free of contamination.

[hopper]

you could maybe do it without 2 pumps less heat or 2 pumps on low


dose pump 1 have a shower nozle thing or dose is the water a solid streem to the outer water res

[STEvil]

both are shower heads. He is cycling the res water through the bong in the picture posted to this thread.