View Full Version : Need advice on 9700pro voltages on modded 8rda+
MoodyB
05-05-2003, 01:06 PM
Hey all,
Just read the Rage3D faq and noticed that it mentioned to increase the agp voltage to 1.7 as a possible cure for lockups.
Will this be safe to do taking into consideration that I have already vdd modded my 8rda+ ? I'm sue I read somewhere that the vdd mod has an affect on the agp voltage in some way, so I like to make sure first of all.
Thanks.
Tweaked!
05-05-2003, 01:25 PM
I'm going to move this over to the mod area, I feel you'll get a more educated response over there:cool:
Welcome to Xtreme:D
MoodyB
05-05-2003, 01:32 PM
Thanks:)
xxORBxx
05-07-2003, 11:54 AM
I fried my first 9700 pro and a gf2gts from the VDD mod so im pretty sure it does something to the AGP but im not sure. Be careful. Since i did the vdd again, i have ran at 1.7 and it seemed fine.
MoodyB
05-07-2003, 04:13 PM
Thanks for the reply.Can you remember what you had the vdd set at when the cards 'toasted' :eek:
Currently sitting at 1.80vdd - 200mhz . I asking since I'll need a 512mb TwinMOS stick soon and was planning on upping the vdd slightly to keep mu overclock.
xxORBxx
05-07-2003, 04:36 PM
It fried right when i did the mod. It was probably at like 2.4v or somthing crazy. It never got to the bios so i couldnt check. I took off the resistor and the next time i did it i used a PCI card to make sure it was at the right volts. ive had it to 1.95 and everything was fine.
CSOFT
05-27-2003, 07:13 PM
I ran 2.4V into mine, It came on but locked in the BIOS, I used the pencil trick with a aid of a conductive pen, but I got to much conductive ink on it and jumped from 1.7 to 2.4V. It did not hurt the board or anything so I just cleaned it up a little and it was fine at 1.8V