SAE
04-28-2003, 09:59 AM
I did the Vcc mod some weeks ago and was expecting an easier way to mod the new 2.0 but this board I am rma-ing.
So I am back with my 1.1. And I have strange probs getting a stable V-out on Vcc. Under stress the line fluctuates between 3,10 and 2,96V. :mad:
I tried increasing the voltage but noticed there must be an OVP b/c I cannot get over 3,12Volts max. Above the board is beeping on me like no ram is inserted and then getting more and more absurd tones... :confused:
Increased the resistance and the board came back.
But it had probs getting into win stably and so I turned the pot back to 100 ohms.
I 'm a little hopeless cause I did not hear/read anything about Ram-OVP before... (if I remember right MrIcee said sth before about an issue he had figuring out the mod on his 1.0)
Maybe somebody has an idea?
Help much appreciated.
THX
So I am back with my 1.1. And I have strange probs getting a stable V-out on Vcc. Under stress the line fluctuates between 3,10 and 2,96V. :mad:
I tried increasing the voltage but noticed there must be an OVP b/c I cannot get over 3,12Volts max. Above the board is beeping on me like no ram is inserted and then getting more and more absurd tones... :confused:
Increased the resistance and the board came back.
But it had probs getting into win stably and so I turned the pot back to 100 ohms.
I 'm a little hopeless cause I did not hear/read anything about Ram-OVP before... (if I remember right MrIcee said sth before about an issue he had figuring out the mod on his 1.0)
Maybe somebody has an idea?
Help much appreciated.
THX