Espen
04-22-2003, 02:56 PM
Ok, I was gonna remove the heat plate on my 9700 pro when i noticed the volt regulator chip (I think) was missing. I found it shortly after glued into the heat plate... Here is a pic :
http://www.flink.no/espen.saether/9700/radeon9700.jpg
And the chip:
http://www.flink.no/espen.saether/chip/chip.jpg
It will be hard to solder the chip back on because the pins are cut almoust inside the chip.
Is it safe to run the card WO this chip?
Thanks
http://www.flink.no/espen.saether/9700/radeon9700.jpg
And the chip:
http://www.flink.no/espen.saether/chip/chip.jpg
It will be hard to solder the chip back on because the pins are cut almoust inside the chip.
Is it safe to run the card WO this chip?
Thanks