PDA

View Full Version : Finalizing setup, questions or comments?


fhpchris
09-05-2006, 08:35 PM
A few questions about the setup I want to run before I finish ordering everything.

This is going to cool my E6600(1.65+V) / X1900, in my V2000.

Pump = Iwaki MD-20 (on the way)
CPU= MP-05 SP LE
Rad= MCR-320
Fans= 3x Sanyo Denki 120x38
GPU= MP-1

T-Line, worm clamps, 3/4FPT to 1/2OD barbs for pump
7/16(5/8OD) Masterkleer
Pentosin G11 for an additive

Rad will be mounted with a radbox.

Does this look like a solid setup? Should I be looking at a BIX3/storm?
septim
09-05-2006, 08:50 PM
the storm would be nice especially with that monster pump...
also for rad go thermochill PA120.3 all the way...
fhpchris
09-05-2006, 09:27 PM
From what I could tell, both blocks perform in a similar matter, and the strom might only be better without a heatspreader.

I am not going to get a PA120.3, the fin density is just uber low, it would be really pointless with denkis, and I refuse to pay the cost differene.
septim
09-06-2006, 05:42 AM
i did try the sanyo denkis with my PA, figured a hot summer day it would be put to good use...

but basically your setup is already nice, add that storm = better...
afireinside
09-06-2006, 06:01 AM
Storm IS better but come on we're dealing with an IHS here, the difference is tiny.
fhpchris
09-06-2006, 08:31 AM
Storm IS better but come on we're dealing with an IHS here, the difference is tiny.


Yes, just by looking at the blocks it looks like the MP-05 cools a larger area than the storm does, and the difference without a spreader is really hard to see.