NorthernYankee
06-16-2002, 03:32 PM
Ok guys I got everything insulated. And all is running but my Temps are higher now than they were before the pelt so I know I must be doing something wrong.
As a refresher here is my setup.
Abit KX7
XP 2000+
Maze 3-1
Aqua Coil
Mag 250gph
13.8v 25 amp PSU
226w pelt
temps at load will hit over 46c before that is about 4c higher than before. and if I implement the Halt command to idle the CPU in Wpcredit, temps only go to about 2c below ambient case temp.
I am not sure if this will make a difference but I did not use AS between the tec and the coldplte or the tec and the waterblock.
I need help badly
--NY
As a refresher here is my setup.
Abit KX7
XP 2000+
Maze 3-1
Aqua Coil
Mag 250gph
13.8v 25 amp PSU
226w pelt
temps at load will hit over 46c before that is about 4c higher than before. and if I implement the Halt command to idle the CPU in Wpcredit, temps only go to about 2c below ambient case temp.
I am not sure if this will make a difference but I did not use AS between the tec and the coldplte or the tec and the waterblock.
I need help badly
--NY