Marci
04-05-2003, 07:24 AM
We have a slight problem here... in the middle of building a TEC rig and we just aren't getitng the temps we reckon we should be getting....
Epox 8RDA+
XP2100 B Core
1GB XMS3500
Meanwell s-320-12 PSU
226w TEC
Maze3-1 on CPU, Z-Chipset on NB, GPU Block on GPU (GF4 Ti46).
Eheim 1250 Pump.
All on 1/2" tubing.
UNDERclocked the chip to XP1500+ speeds at 1.5v and the Core still doesn't get down to the minus figures. It sits at 7 degrees. Water temp is a consistent 30 degrees using a Thermochill 3x120 rad with 3x Panaflos running at 12v on it.
Now, my XP2400+ when underclocked & undervolted by the same PERCENTAGE runs at -6 to -10 depending on ambients. This is the exact same cooling setup but on someone else's rig....
We've tried reseating all blocks etc, tried changing pelt, tweaked PSU... nothing seems to make a difference.
Any clues?
Epox 8RDA+
XP2100 B Core
1GB XMS3500
Meanwell s-320-12 PSU
226w TEC
Maze3-1 on CPU, Z-Chipset on NB, GPU Block on GPU (GF4 Ti46).
Eheim 1250 Pump.
All on 1/2" tubing.
UNDERclocked the chip to XP1500+ speeds at 1.5v and the Core still doesn't get down to the minus figures. It sits at 7 degrees. Water temp is a consistent 30 degrees using a Thermochill 3x120 rad with 3x Panaflos running at 12v on it.
Now, my XP2400+ when underclocked & undervolted by the same PERCENTAGE runs at -6 to -10 depending on ambients. This is the exact same cooling setup but on someone else's rig....
We've tried reseating all blocks etc, tried changing pelt, tweaked PSU... nothing seems to make a difference.
Any clues?