GSkill GBHZ on DFI EXPERT

[WulleWuu]

Hi
I have a DFI Expert Board and the 2Gb Kit GBHZ. I want to run them with 250
Mhz and i dont know the other settings in the more than complicated Bios of
the board.
I use the 4/6/06 Bios, the newest from the DFI Page for the Expert Board.
Maybe u can send me some Screenshots or something with the optimal and fix timings and can tell me which settings are important for a stable system and which i can try, to get a stable system. Now many settings are on AUTO, but this isnt working well. I tested it with Prime95, u know?


Greets

[GSKILL TECH]

try DDS between 1~4 and DDDS on 1
that is most important thing

[WulleWuu]

And the rest? There are more than 20 Settings.... maybe do u have screen or a list? Plz!

[GSKILL TECH]

you can refer to http://www.xtremesystems.org/forums/showthread.php?t=95044
most the setting ultra-D and expert are the same

[WulleWuu]

Hrm ok.. most, but not all.. so i need to try and try and try. I already tried all these settings and i mixed them up. It is always unstable. But ok, i see u cant give me a screenshot or a list with settings tested on a expert :(

[The Nemesis]

Here's what I use, My memory is stable beyond 275mhz but I'm told I have a good batch. My serials start with 0603.

Dram Frequency Set: 200 (1:1)
Command Per Clock: Enable
Cas: 3
Trcd: 4
Tras: 8
Trp: 3
Trc: 7
Trfc: 16
Trrd: 2
Ter: 2
Twtr: 2
Trwt: 3
Tref: 3684or auto
Odd Divisor Correct: Enable
Dram Bank Interleave: Enable

Dqs Skew Control: Auto
Dqs Skew Value: 0
Dram Drive Strength: 7
Dram Date Drive Strength: Auto
Max Async Latency: 8ns
Dram Response: Normal
Read Preamble Time: 5ns
Idlecycle Limit: 256 cycles
Dynamic Counter: Disable
R/w Queue Bypass:16
Bypass Max: 7
32 Byte Granularity: Disable

[WulleWuu]

What is Odd Divisor Correct?

I was told, that i need to disable it, cause i use a Divider