Intel D975XBX "Bad Axe how increase bus over 1333mhz?help me!

[Terminator82]

i had buy this mobo revision 304 with a conroe e6400, in this forum i have been saw many post with people tath increase bus up to 500mhz quad pumbed 2000mhz but in bios config can i set onli 30% of overclock over official speed ...
I read that there is the possibility to sold two pin of oc debug to unlock vcore setting in the bios with this mod can increase bus form the bios to 400 mhz?
how do i make to overclock my processor to 2.9 ghz at the boot and no with clock gen???????????

[sierra_bound]

The Bad Axe does not have what you're thinking of. It uses burn-in mode which allows percentage increases over the N/B CPU strap that you set. For example, the 1333MHz strap (FSB Frequency Override in BIOS) would put your base FSB at 333. If you combine that with burn-in mode at 20%, that would give you 400 for FSB.

Only one person has gotten FSB up to 500 and he was using a heavily-modded Bad Axe board with extreme voltages. 2.9v for VDimm. Not recommended for most users. :)

[Terminator82]

i thought that burn in %override and fsb setting didn't use together is possible to combine ?
for example hai setting my cpu bus 1333mhz and 5 % of burin in % is possible ?

[sierra_bound]

Yes, you can use them together. That's what a lot of people do. ;)

[Terminator82]

thanks a lot now i will go to make a mod :D:D:D:D:D:D:D:D:D