Swiftdeathz
02-28-2003, 02:22 PM
Ok guys... I still haven't been able to find a picture of how to connect SMD grabbers with the wire/resistor...
The SMD grabbers have a tiny hole in them which is surrounded by what looks like to be some copper material...
I've been reading that you have to properly insulate the connection to prevent any shortages...
What I'm confused about is how to connect either the wire or the actual fixed resistor to the SMD grabbers...
Do I just use the wire that I have and jam it in that tiny hole as best I can then connect the other end of the wire to the resistor leg?? Or can I completely forget about the wire and just stick the resistor leg into that hole in the SMD grabber?? Or do I have to go to Radioshack and buy some type of wire that will fit perfectly into the hole of the SMD grabber then just tie up the other end of that wire to the resistory legs??
Please someone throw me a bone... I know I must sound like a total noob but I am when it comes to mods... Someone plz help me because I don't want to fry my board after it has treated me so well... :p
The SMD grabbers have a tiny hole in them which is surrounded by what looks like to be some copper material...
I've been reading that you have to properly insulate the connection to prevent any shortages...
What I'm confused about is how to connect either the wire or the actual fixed resistor to the SMD grabbers...
Do I just use the wire that I have and jam it in that tiny hole as best I can then connect the other end of the wire to the resistor leg?? Or can I completely forget about the wire and just stick the resistor leg into that hole in the SMD grabber?? Or do I have to go to Radioshack and buy some type of wire that will fit perfectly into the hole of the SMD grabber then just tie up the other end of that wire to the resistory legs??
Please someone throw me a bone... I know I must sound like a total noob but I am when it comes to mods... Someone plz help me because I don't want to fry my board after it has treated me so well... :p