Will the BIX fit here....

[#ball3r]

I'm buying a new modded Lian-Li PC75 case and was wondering if I could put the BIX w/2 120mm fans above the PSU in the attached pics? If so can you post options of install and what would be best (ie. maybe with 1 fan and rad outside)? Also which way should the fans be pushing air? I'm going to be putting a window and 92mm exhaust fan on the top so that should help some. In total there will be 2 80mm front intake, 2 80 rear exhaust, 1 92mm top exhaust, and the 2 120mm for the radiator. I was thinking of also getting a 92mm intake hole in my side window, but was thinking it would be overkill. I will be cooling the vid card and chipset with water blocks anyway, so what do you think?

[#ball3r]

another pic...

[#ball3r]

one more...

[KnightElite]

It looks like it might fit if you put it sideways.... not 100% sure though.

[Mark Larson]

Damn, that thing would be overkill with only half the fans you listed! :eek:

Anyway, the way i've seen most PC-7x setups is with the rad/core attached to the top of the case, with a duct bringing in fresh air from the back (where your current 120mm is) and exhausting it through the core at the top. Make sense? I don't know the BIX's dimensions but this would surely be the way to go if you were using a heatercore.