Nohto
06-12-2002, 12:03 PM
Power Supply Modifications
Many users are experiencing extremely low 5.00V values when using higher than default Vcore settings in bios. Components used for our alignment and modification are of the highest quality in the electronics industry and the components have tighter tolerances than those used by the factory. After the modification you will notice that the fluctuation in Vcore and 5.00V rails will hold a tighter variance in idle and full load conditions resulting in overall system stability. The only drawback is that the 12.00V rail will be around 12.60V which is within 5% of optimal. This may possibly lead to shortened component lifespan. This modification is only recommended for those who are using water, TEC, phase change and other extreme cooling methods. The modification is implemented with the factory designated overload protection taken in consideration. Each unit is tested for 48 hours before shipment back to the customer.
XTREME TEK WERKZ (http://www.xtwerkz.com/XTWmods.htm)
Has anyone had this mod done to their PS? And if so how did it work or have you heard of any other method to raise the 5v values.
Many users are experiencing extremely low 5.00V values when using higher than default Vcore settings in bios. Components used for our alignment and modification are of the highest quality in the electronics industry and the components have tighter tolerances than those used by the factory. After the modification you will notice that the fluctuation in Vcore and 5.00V rails will hold a tighter variance in idle and full load conditions resulting in overall system stability. The only drawback is that the 12.00V rail will be around 12.60V which is within 5% of optimal. This may possibly lead to shortened component lifespan. This modification is only recommended for those who are using water, TEC, phase change and other extreme cooling methods. The modification is implemented with the factory designated overload protection taken in consideration. Each unit is tested for 48 hours before shipment back to the customer.
XTREME TEK WERKZ (http://www.xtwerkz.com/XTWmods.htm)
Has anyone had this mod done to their PS? And if so how did it work or have you heard of any other method to raise the 5v values.