VDROOP really needed on the AOpen/Yonah mobo..

[NapalmV5]

at least on mine and a few others...

no mod bios @ 1.5v - 1.35v under load
v mod bios @ 1.7v - 1.35v under load

so.. whos willing to help? have had a rough weekend no mood to trace the vdroop.. Anyone? Please!

[kiwi]

What voltage measure point did you use?

[lawrywild]

sounds like you're reading the wrong voltage or your using some crappy software..

[NapalmV5]

kiwi, the v regulators are good measuring points.. so im using them as the main measuring points..

lawry, no software.. cant even trust the bios.. using a multimeter..

[lawrywild]

http://i19.photobucket.com/albums/b178/cybershot033/vcore-mod.jpg


are you reading from the mosfet?

[kiwi]

It is not correct measure point (at least for me), check mods section, I've marked the correct measure point there :)

[NapalmV5]

dat measuring point shows wat the modded resistor shows but the resistor right next to it shows minus -0.15v just like the v regulators.. i just dont see the cpu getting higher voltage dan 1.35-1.40v

im really fed up with this setup, stomak sick..