Please help with MAch 2 GT!!!!

[Kendragon]

I think either my controller board, or sensor is going bad. I can see temps around 60 deg c positive, yet the compressor is cooling the head, ice visible. If i cannot get a replacement board or sensor, can I bypass the chip controller all together?? Any help would be a ppreciated. Good luck trying to contact ECT.:mad:

[fatty]

First off try flashing the firmware visit extremeprometia.com the software is on the forum somewhere ( sorry too lazy to find it for you ) if flashing the firmware does not help you can purchase replacement boards or you could just disconnect the compressor from the board and plug it straight in but then you loose any temp readings and protection
Another alternative to the mach controller is the G Froster as discussed here http://www.xtremesystems.org/forums/showthread.php?t=49823