PC4000 VX Gold settings...

[NightCrawler™]

I've been playing with the settings for this mem stick but I'm not sure if they are the right ones or if they qualify for improvement..

My memory is running on the fixed DFI 3.3v jumper trick... I'm using the 704-2a BIOS...
Tref is set at 1560... But I'm trying to figure out the drive strength.... for now it's set at 4 weak... but I'm puzzled about the levels 1-3.. :confused:

Also with these settings and my 4400x2.. are these superpi runs any good....?

http://img58.imageshack.us/img58/4126/ocztimings4tk.th.gif (http://img58.imageshack.us/my.php?image=ocztimings4tk.gif)

NCâ„¢

[NightCrawler™]

No advice... pointers.....??

Thanks.... [/end sarcasm]

NC™

[kiwi]

Seems fine to me although I run drive/data strength 7/2 or better auto/auto on NF4.

You can set idle cycle to 256 and disable Dynamic counter for stability.

Also some UTT sticks don't like trc/trfc that low, at least my mushkin did not. You might wanna try 9/16 or so

[HiJon89]

My BH-5 seems to like 3 Weak for Drive Strength and 3 for Data Drive Strength. You could also try Tref 3120, running CPU at 11 multi, Max Async Latency to 7ns, Read Preamble to 5ns, Disable Dynamic Idle Cycle Counter, Fast setting for DRAM Response Time, and Twtr to 1.

[NightCrawler™]

Thanks for the input... I've disabled the Dynamic counter for now... running at multi 11x seems much slower on my system...

Right now due to other issues I went back to the 623-2 Bios so I need to work on other settings again..

NC™