bAdboLL
01-07-2006, 12:45 PM
I only want two modes on my card, 2d and 3d performance.
In 2d mode the card shall run at 275/1050 and in 3d performance its going to run at 480/1250 + delta 20.
Is this possible to fix?
As it is now, when i start ATi Tool or something like that to check the clock out, the card only goes in 3d low power, 468 mhz (450+20) instead of 501mhz when its running at performance mode.
I got my Zalman VF700-CU connected right to the card, i have set the fan speed to 25% in 2d, 70% in 3d low and 100% in 3d performance.
But even though i have done that, the fan stays at 100% speed all the time, even if i wait a long time after i have run 3dmark etc, i want the fan speed to slow down as soon as the cord clocks down itselt into 2d mode.
Is this possible to fix? :banana:
Thanksful for help!
In 2d mode the card shall run at 275/1050 and in 3d performance its going to run at 480/1250 + delta 20.
Is this possible to fix?
As it is now, when i start ATi Tool or something like that to check the clock out, the card only goes in 3d low power, 468 mhz (450+20) instead of 501mhz when its running at performance mode.
I got my Zalman VF700-CU connected right to the card, i have set the fan speed to 25% in 2d, 70% in 3d low and 100% in 3d performance.
But even though i have done that, the fan stays at 100% speed all the time, even if i wait a long time after i have run 3dmark etc, i want the fan speed to slow down as soon as the cord clocks down itselt into 2d mode.
Is this possible to fix? :banana:
Thanksful for help!