Lestat
12-23-2005, 06:51 PM
ok well i got my cellie D 2.1ghz in .. system boots up fine it sees the Cellie d properly
but in the bios
1)
it lists only VID control as 1 thru 62 .. huh ? what ?
2)
there is no FSB options
3)
no agp options as in freq
4)
basically nothing i can do via the bios to change anything important other than dram cas timings. and dram freq (which is max 333 since the cpu is only a 533mhz bus)
right now using clockgen i can go to 3.2ghz without blinking but any higher and the aGP bus goes kaboom up to 100mhz and the system freezes.
oddly enough i did this and rebooted and the cpu was still at 3.2ghz ? yup you heard me it was stuck at 3.2ghz even after rebooting without running clockgen again
i thought this baord had all the options accept a chipset voltages ?
according to this thread it does
http://www.hardforum.com/showthread.php?t=900405
(sorry for the link to the H its the only link there)
lastly it has a bios dataed 09/05/2005 bios rev 1018.001 this bios isnt even on the asus ftp
obviously this is a beta bt a beta so bad that all the oc options are gone ?
do i dare go back to the 1017 bios i fear if i do that i may lose Pent D support or worse,, voltages me go back to a high setting and hurt the chip
or do i not need to worry the pent D is ok even if not officially supported?
any help is appreciated i didnt want to get asus as ive had nothing but crap from them in the area of mobo's but i really figured this would be the little brother of the P4P800 series board which was , correct me if im wrong, a very superior 478 board ....
any help is greatly appreaciated fellas.
but in the bios
1)
it lists only VID control as 1 thru 62 .. huh ? what ?
2)
there is no FSB options
3)
no agp options as in freq
4)
basically nothing i can do via the bios to change anything important other than dram cas timings. and dram freq (which is max 333 since the cpu is only a 533mhz bus)
right now using clockgen i can go to 3.2ghz without blinking but any higher and the aGP bus goes kaboom up to 100mhz and the system freezes.
oddly enough i did this and rebooted and the cpu was still at 3.2ghz ? yup you heard me it was stuck at 3.2ghz even after rebooting without running clockgen again
i thought this baord had all the options accept a chipset voltages ?
according to this thread it does
http://www.hardforum.com/showthread.php?t=900405
(sorry for the link to the H its the only link there)
lastly it has a bios dataed 09/05/2005 bios rev 1018.001 this bios isnt even on the asus ftp
obviously this is a beta bt a beta so bad that all the oc options are gone ?
do i dare go back to the 1017 bios i fear if i do that i may lose Pent D support or worse,, voltages me go back to a high setting and hurt the chip
or do i not need to worry the pent D is ok even if not officially supported?
any help is appreciated i didnt want to get asus as ive had nothing but crap from them in the area of mobo's but i really figured this would be the little brother of the P4P800 series board which was , correct me if im wrong, a very superior 478 board ....
any help is greatly appreaciated fellas.