Sir Lancelot
12-10-2005, 07:41 PM
I was wondering if there's any turn around to the kwon cold boot of P5WD2 boards...
While I'm overclocking, each time I have to reboot, the PC shuts down for a couple of seconds and turns on back again by itself...
In the meantime, the prommy is on shut down process when the PC suddenly turn on...
I'm afraid that in time, this will send my prometeia to the garbage...:mad:
So, isn't there any wire trick or something that could avoid that mach2 doesn't start to shut and waits a couple of seconds before starting the turn off process??
I was thinking on disconnecting the molex from the power supply to mach2...but I'm not sure if that's a good ideia...
Thankx for the support guys!
While I'm overclocking, each time I have to reboot, the PC shuts down for a couple of seconds and turns on back again by itself...
In the meantime, the prommy is on shut down process when the PC suddenly turn on...
I'm afraid that in time, this will send my prometeia to the garbage...:mad:
So, isn't there any wire trick or something that could avoid that mach2 doesn't start to shut and waits a couple of seconds before starting the turn off process??
I was thinking on disconnecting the molex from the power supply to mach2...but I'm not sure if that's a good ideia...
Thankx for the support guys!